About

SCOPE OF WORK “ LT DISTRIBUTION POWER SUPPLY PANELS

Each Panel should be equipped with the following:

A. 125 Ampere Main Incomer MCCB Four Pole with Electronic Trip and Rotary Extended Handle with

36 KA Rating and Spreader Links for Termination. (Qty.= 01 NO.)

B. Outgoing four pole MCCB with thermal magnetic trip, in separate compartment.

100 AMP (Qty.= 01 NO.)

63 AMP (Qty.= 03 NOS.)

Outgoing MCB™s

25 AMP 4P (Qty.= 16 NOS.)

C. Suitably rated Copper Bus bar

Size = 30 x 5 mounted in separate bus bar section.

D. Bottom/ top cable entry with suitable glands on cable gland plate.

E. Panel to be IP 54 rated. (Wall mounted / Base mounted with necessary G.I. Stand height of about

600 mm from ground or as per site requirement) - (Qty.= 1 NO.)

F. Multifunction Meter to be added with Suitable Fuses and Transformer (Qty.= 1 NO.)

G. Indication lamps for incoming and outgoing supply and incomer breaker on/off status. (Qty.= 1

SET)

H. Electrical insulated rubber mats as per standard IS 5424/84 or IS 15652:2006 to be provided in front

of each panel (Size: 1000 mm x 1000 mm x 2.5 mm) (Qty.= 1 NO.)

Each panel to have three sections i.e. Main incomer, bus bar and outgoing feeders.

Size of panel (approximately)

Height “ 1600 - mm, Width - 1000 mm, Depth “ 500 mm

All dimensions + 100 mm will be acceptable.